		* required information
Parameter	Description		Value	Example	Maximum
Your callsign	Your own callsign	*			-
Your email address	The email address to send firmware to	*
Crystal frequency	The frequency of the crystal (X1) used in the keyer hardware	*	MHz	3,2758	4
Beacon callsign	The callsign sent when operating from the normal location	*	chars	OZ7IGY	8
Service callsign	The callsign sent when the beacon is in service mode	*	chars	OZ7IGY/A	8
Beacon locator	The locator sent when operating from the normal location	*	chars	JO55WM	8
Service locator	Locator sent when the beacon is in service mode and from an alternative location	*	chars	JO65ER	8
Extra message	An extra message sent when activated, e.g. about propagation.		chars	AUR	3
Number of IDs	The number of times the last letter (service) call ID is sent.	*		10	254
Key down	The duration that the beacon is sending a constant carrier, or 50% duty cycle	*	seconds	20	50
Keying speed	The speed at which the beacon sends its message (60 LPM = 12 WPM)	*	LPM	60	200
RX pause	The duration of the pause when the PTT is deactivated	*	seconds	10	254
Boot pause	Optional 10 s boot pause delay to prevent immediate PTT when powered up	*	YesNo	No	-